Peg Perego Vela Easy Drive Stroller User Manual download pdf (Page 11)

- 11 -

EN_English

Thank you for choosing a Peg-Pérego product.

WARNING

_

CAREFULLY READ INSTRUCTIONS

AND KEEP FOR FUTURE USE.

THE CHILD’S SAFETY COULD

BE PUT

AT RISK IF THE INSTRUCTIONS ARE NOT

FOLLOWED.

_ THIS PRODUCT IS DESIGNED FOR A

CHILD WHOSE MAXIMUM WEIGHT

IS 45 POUNDS (20 KG) AND WHOSE

MAXIMUM HEIGHT IS 43 INCHES

(110 CM). THIS SHOPPER BASKET IS

DESIGNED TO CARRY A MAXIMUM

WEIGHT OF 11 POUNDS (5 KG). ANY

CUPHOLDER EVENTUALLY PROVIDED

WITH THIS UNIT IS DESIGNED

TO CARRY A MAXIMUM WEIGHT

SPECIFIED ON THE CUPHOLDER

ITSELF. ANY POACH OR POCKET

PROVIDED WITH THIS UNIT IS

DESIGNED TO CARRY A MAXIMUM

WEIGHT OF 0.44 POUNDS (0.2 KG).

_ FAILURE TO FOLLOW

MANUFACTURER’S SPECIFICATIONS

OR USE OF ACCESSORIES OTHER

THAN THOSE APPROVED BY THE

MANUFACTURER MAY CAUSE THE

UNIT TO BECOME UNSTABLE.

_ AVOID SERIOUS INJURY FROM

FALLING OR SLIDING OUT. ALWAYS

USE COMPLETE 5 POINT SEAT BELT.

_ NEVER LEAVE YOUR CHILD

UNATTENDED.

_ ALWAYS USE ALL THE BRAKES

WHENEVER PARKED.

_ TO AVOID SERIOUS INJURY, WHEN

MAKING ADJUSTMENTS ENSURE

THE CHILD’S BODY IS CLEAR OF ALL

MOVING PARTS.

_ ALL OPERATING AND ASSEMBLY

PROCEDURES SHOULD BE

PERFORMED BY AN ADULT.

_ DO NOT LIFT THE STROLLER BY

GRIPPING THE FRONT BAR. THE

FRONT BAR IS NOT DESIGNED TO

WITHSTAND LOADS.

_ ENSURE THAT THE STROLLER IS

OPENED CORRECTLY AND LOCKED IN

POSITION OF USE.

_ CHECK TO MAKE SURE THAT THE

CAR SEAT OR THE BABY CARRIAGE

IS CORRECTLY FASTENED TO THE

STROLLER (WHERE APPLICABLE).

_ DO NOT DRIVE THIS PRODUCT

AROUND STAIRS OR STEPS; CARE

MUST BE TAKEN IF UNIT IS USED ON

STAIRS OR ESCALATORS.

_ DO NOT USE THE PRODUCT IF IT HAS

BROKEN OR MISSING PARTS.

_ DO NOT USE NEAR FIRE OR EXPOSED

FLAME.

_ NOTICE: THIS ARTICLE MEETS OR

EXCEEDS ALL REQUIREMENTS

COVERED IN ASTM F833 STANDARD

AND LATEST REVISIONS.

_ MAKE SURE THAT THE REAR LEDGE IS

ALWAYS SECURELY ATTACHED USING

THE SCREW SUPPLIED.

INSTRUCTIONS

1 OPENING THE STROLLER: (fig_a) To open the

stroller, lift the lever on the handlebar (fig_a)

until the safety hooks are unfastened; lift the

handlebar all the way up (fig_b), then push it

all the way down to the final click (fig_c).

2 FRONT WHEEL ASSEMBLY: before inserting

the wheel, straighten the footrest, insert the

nut and then insert the screws under the

footrest, tightening them to hold it in place

(fig_a). Now press the button (fig_b) and slide

the wheels on until you hear a click (fig_c),

then check that they are connected correctly

(fig_d).

3 ASSEMBLING THE BASKET: Attach the screw

and the stabilizer to the basket rod and

tighten (fig_a). Fasten the basket on the front

to the hooks (fig_b), button it on the rear and

fasten it internally to the sides (fig_d).

4 FRONT BAR-TRAY: Place and attach the front

bar-tray (fig_a). To open the front bar on

one side only, press one of the two buttons

placed underneath and turn it upwards (fig_

b). To remove it, press both buttons and pull

it upwards at the same time (fig_c). Do not

place hot drinks on the front bar-tray because

it could be dangerous.

5 HOOD: To attach the hood, insert the tabs

into the notches (fig_a) and button the hood

to the rear of the backrest (fig_b).

6 The hood can be moved to different positions

while your child is sleeping (fig_a). To remove

the hood, press the side buttons while lifting

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Comments to this Manuals

No comments